News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Axeman

#1
I'm getting -23.7vdc and moreover it works great
#2
It works great
#3
Awesome, thanks Brian
#4
Tech Help - Projects Page / Total Recall Power supply
August 14, 2021, 11:37:36 PM
Hey guys, I just ordered a EHX 24Vdc from Amazon for my Total Recall build.  Before adding power to the pedal, I measured the output of the power supply and I was reading 32.3Vdc.  Can I use it safely?  Any help would be appreciated.

Thanks
#5
Tech Help - Projects Page / Re: Aion Stratus
December 11, 2019, 09:42:09 PM
Got it working wrong resistors. I mistakenly used 510 ohms instead of 510K.
#6
Tech Help - Projects Page / Re: Aion Stratus
November 17, 2019, 01:49:23 PM
Let me clarify, It's almost no volume, you can barely hear it.  Like a broken speaker.
#7
Tech Help - Projects Page / Aion Stratus
November 17, 2019, 02:10:20 AM
Anyone here has had a problem with the volume being to low on a Stratus Aion build?
#8
OK got it working Q11 and Q12 (MPSA13) replaced.  The way I figured it out was by shorting the ground on Q11.  Hope that helps someone else.
#9
So I finished My Harbinger 1.5 today when I powered it up 9V the bulb pulsated for about 3 seconds and the light remained steady.  so I disconnected the power and tried it again, and same thing pulsates then stops. ??????
Any help
#10
Tech Help - Etcher's Paradise / Re: NomNom pedal
October 22, 2019, 12:57:44 AM
Do you know what I can do to mod the NomNom so the effect to start early ?
#11
Tech Help - Etcher's Paradise / Re: NomNom pedal
October 21, 2019, 09:13:50 PM
Thanks, I screwed I had the Diodes swapped.  All good now, but I used a 20k trimm instead of a 25k, I wonder what's the difference
#12
Tech Help - Etcher's Paradise / NomNom pedal
October 21, 2019, 06:00:30 PM
Ok, so I built this pedal with all the correct components and took my time.  The pedal sounds like a broken speaker, not sure whats wrong.  Can someone help with the troubleshooting?
#13
I hope so, it's my next project
#14
That's some bull shit, the board is faulty?
#15
Q11 and 12 are new 2n5088 and Q13 is a MPSA13.  I'm going to replace the Darlington transistors again.