Messages

I got it!!!! Silly me I misinterpreted the wiring diagram so I had the in/out jacks reversed. I will forever check my continuity between ground and the in/out jacks. Thanks again for the quick feedback and I'm really happy with my build and the quality of the PCB. Sound wise, I was pleasantly surprised how much more bottom end passes through the MK1 vs the MK2 I compared it to. The extra delay time is nice as well. Case closed!

Thanks so much! Good thing I soldered leads to the pot for easy removal for such things as this. I'll be able to check tonight and report back.

Hello! My 2016 AquaBoy with Aqua Puss values does indeed provide really nice delays as it should. My only problem is I'm trying to figure out if I should be able to achieve a single repeat with the feedback all the way down. With the feedback dial all the way down, I hear about 5 repeats. I can dial up the repeats fine which sends the pedal into oscillation pretty easily too because of this. I double checked wiring, double checked pot values, triple checked calibration, values seem to be correct.. for IC's I'm using:

OnSemiconductor NE570D (using a SMD to DIP converter)
Xvive MN3005 from Small Bear
MN3101 from small bear
4558

I simply followed the instruction for AquaPuss values
"- To build the original Way Huge® Aquapuss™ on the Aquaboy board
Add a 470pF cap in parallel with R1
Make R6, R7, R8 and R10 47.5k instead of 47k
C14 100n instead of 82n
C2, C16, C23 and C7 10uF instead of 1uF "

I swapped the NE570 with a SA571 with no difference. Anything else that I should check and/or is this expected behavior? Thanks for the help in advance!