News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - loreluc64

#1
thanks a lot for your very appreciated job !!

#2
please see my other post, in my opinion there is a mistake in the schematic (47nF capacitor missing) which cause bad voltages on Q2 :

http://www.madbeanpedals.com/forum/index.php?topic=27311.msg264418#msg264418

best regards
#3
Dear all,
i've seen the schematic posted on freestompboxes and i noticed that on ANKH is missing a capacitor (C4 on fsb schematic with value 47nf) which connect lug 2 of Gain pot to Q2 Gate.
Fortunately it correspond on ANKH board on the longest wire bridge , so just replacing the wire with a 47nF capacitor the ANKH became identical to fsb schematic.
I noticed also that on some breadboard circuit found on internet the same capacitor 47nF is used at the same time so i supposed is necessary and if omitted could compromise Q2 polarization.
See in attachment freestompboxes schematic.

Lorenzo (from Italy)