Hello everyone,
I'm a beginner with a few vero builds, but not many pcbs. I had to change the 7815 a few times, thinking I was frying them and I wonder if I haven't managed to burn or melt the pcb now. I have taken voltage readings on the in and out pins, both from ground and +18 v, giving 0 each time.
See the pics below, it's ugly. What do you think? Is there a way to fix it? Or should I start over?
Thanks!
Pierre.
I'm a beginner with a few vero builds, but not many pcbs. I had to change the 7815 a few times, thinking I was frying them and I wonder if I haven't managed to burn or melt the pcb now. I have taken voltage readings on the in and out pins, both from ground and +18 v, giving 0 each time.
See the pics below, it's ugly. What do you think? Is there a way to fix it? Or should I start over?
Thanks!
Pierre.