Topics

Hey guys, I just ordered a EHX 24Vdc from Amazon for my Total Recall build.  Before adding power to the pedal, I measured the output of the power supply and I was reading 32.3Vdc.  Can I use it safely?  Any help would be appreciated.

Thanks

Anyone here has had a problem with the volume being to low on a Stratus Aion build?

So I finished My Harbinger 1.5 today when I powered it up 9V the bulb pulsated for about 3 seconds and the light remained steady.  so I disconnected the power and tried it again, and same thing pulsates then stops.
Any help

Ok, so I built this pedal with all the correct components and took my time.  The pedal sounds like a broken speaker, not sure whats wrong.  Can someone help with the troubleshooting?

Hi everyone new here and would like to introduce myself. I've been building Marshall Plexi clones for about ten years now and never looked into pedals other than a TS. After stumbling across Aion web site I was very impressed of all the option of pedals that can be made rite at home. Kevin referred me to this web site for a Octavia and a Uni-Vibe project. After finishing my Octavia without any problems I dove rite into the HarbingerOne, finished it and was very happy that my enclosure married up perfectly to the pcb, pot's and switches. One problem, it does not work. I can't figure it out, I followed every detail of the PDF instructions and the light does not pulsate and when I press the on and off switch, no sound.
Can someone help.