I've gone through and checked all my resistor values and component orientation, still getting no effect, and some wonky voltage readings. I haven't wired up R9 yet (planning on putting in a vibe switch) but if I place the resistor in the holes, I still get dry signal with the effect engaged. The rate LED lights up and changes with the Rate knob.
Here are my IC voltage readings:
Transistor voltages:
V+ measured at the board is 9.08 (coming from a wall wart)
Any help would be greatly appreciated!
Here are my IC voltage readings:
IC1 | IC2 | IC3 | IC4 |
2.17 | 0 | 8.64 | oscillates |
2.18 | 4.18 | 4.16 | 4.5 |
2.17 | 1.57 | 0 | oscillates |
0 | 8.08 | 4.18 | 0 |
2.17 | 8.64 | 275mv, osciilates | 4.58 |
2.18 | 4.16 | 8.3 | 4.62 |
2.18 | 4.59 | 2.75, oscillates | oscillates |
8.85 | 4.6 | 8.08 | 8.68 |
Transistor voltages:
Q1 | Q2 | Q3 | Q4 | Q5 | |
C | 8.81 | 8.81 | 8.81 | 8.62 | 7.4 |
B | 1.92 | 2.09 | 1.98 | oscillates | 350 mv |
E | 1.42 | 1.54 | 1.46 | oscillates | 0 |
V+ measured at the board is 9.08 (coming from a wall wart)
Any help would be greatly appreciated!