Hello! My 2016 AquaBoy with Aqua Puss values does indeed provide really nice delays as it should. My only problem is I'm trying to figure out if I should be able to achieve a single repeat with the feedback all the way down. With the feedback dial all the way down, I hear about 5 repeats. I can dial up the repeats fine which sends the pedal into oscillation pretty easily too because of this. I double checked wiring, double checked pot values, triple checked calibration, values seem to be correct.. for IC's I'm using:
OnSemiconductor NE570D (using a SMD to DIP converter)
Xvive MN3005 from Small Bear
MN3101 from small bear
4558
I simply followed the instruction for AquaPuss values
"- To build the original Way Huge® Aquapuss™ on the Aquaboy board
Add a 470pF cap in parallel with R1
Make R6, R7, R8 and R10 47.5k instead of 47k
C14 100n instead of 82n
C2, C16, C23 and C7 10uF instead of 1uF "
I swapped the NE570 with a SA571 with no difference. Anything else that I should check and/or is this expected behavior? Thanks for the help in advance!
OnSemiconductor NE570D (using a SMD to DIP converter)
Xvive MN3005 from Small Bear
MN3101 from small bear
4558
I simply followed the instruction for AquaPuss values
"- To build the original Way Huge® Aquapuss™ on the Aquaboy board
Add a 470pF cap in parallel with R1
Make R6, R7, R8 and R10 47.5k instead of 47k
C14 100n instead of 82n
C2, C16, C23 and C7 10uF instead of 1uF "
I swapped the NE570 with a SA571 with no difference. Anything else that I should check and/or is this expected behavior? Thanks for the help in advance!