News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - LedZepp007

#1
Build Reports / Re: Lab Series L5 preamp in a pedal
July 22, 2016, 08:08:13 PM
This looks amazing


Sent from my iPhone using Tapatalk
#2
Build Reports / Re: Lab Series L5 preamp in a pedal
July 22, 2016, 07:14:37 PM
This looks amazing


Sent from my iPhone using Tapatalk
#3
Anybody? Bueler?


Sent from my iPhone using Tapatalk
#4
Okay: I believe the 3207 voltages are good now. But, the 3102 remains very high on pins 1 and 8.

Any help would be very much appreciated.


Sent from my iPhone using Tapatalk
#5
Okay. Checked values last night. Some of the resistors were measuring a little low, but all within tolerance I think.

I found a cold solder joint was responsible for the weird 4558 voltages. So, now the TL062 and the 4558 are good. The 3102 and 3207 voltages are still the same. With my test rig, I was able to get some extremely soft effected sound. It was about 1/10th the volume of the bypassed sound and with a lot of static/white noise. The trimmer pot reduced the noise a bit, but the volume was still extremely quiet. Any explanations for why the BBD chips have such strange voltages? I did notice that R41 (33R) is not surprisingly not dropping the voltage to the 3102 much (about 0.1 VDC).


Sent from my iPhone using Tapatalk
#6
Quote from: Govmnt_Lacky on July 19, 2016, 07:04:51 PM
Is this a Rev 1 PCB? If so... did you read the note at the end of the build doc?

Did you jumper properly for the 3102/3207 combo?

What is your R7 value?

What happens when you turn the trimmer?

It's rev 1 and shouldn't need the modification.

I believe so.

R7 should be 10k, but I'll check it when I get home along with the trimmer.

Thanks.


Sent from my iPhone using Tapatalk
#7
Hi,

My PB build isn't working. I have checked the solder joints and voltages. Voltages (with 9.36VDC supply) listed below:

4558:
1: 7.58
2: 7.55
3: 1.0
4: 0.0
5: 3.75
6: 5.51
7: 3.55
8: 9.1

BL3102:
1: 8.38
2: 2.8-3.0
3: 8.4-8.57
4: 0.3
5: 4.39
6: 0.0
7: 4.3
8: 8.97

BL3207
1: 4.32
2: 4.32
3: 4.36
4: 8.99
5: 8.3
6: 3.0
7: 4.3
8: 0.0

TL062:
1: Varies
2: 4.5-4.56
3: Varies
4: 0.0
5: 4.5-4.58
6: 4.54-4.58
7: Varies
8: 9.09

Any help appreciated.



Sent from my iPhone using Tapatalk
#8
Necro thread, but is the IC oriented properly? You should really socket those things.


Sent from my iPhone using Tapatalk