News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - iipeacefrog

#1
Anybody?
#2
Hey guys! Have a few successful builds under my built but I'm having trouble getting the HoneyDripper fully operational. Here's where I'm at:

The pedal half works; the fuzz circuit seems to work fine and increases in nastiness as I turn up the pot; The rotary switch also seems to be switching vowel sounds. When I turn the rotary switch, I hear an initial vowel but then the envelope never resets, and the pedal ends up sounding like a stuck wah pedal. The sweep knob also seemingly does nothing. I've reset all of the IC's, double checked all of my solder joints, triple checked my wiring and can't really figure out what might be going on. The only thing I can think that may be causing issues is that I switched some of the polarized caps with non-polarized equivalents, but in 99% of cases that should be fine...any suggestions?