News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - musovern

#1
Thanks for the help guys,
I have tryed again. This time not with a battery but a 9v power supply. And now the LED's light up, Not very much change in sound so it is a Led problem.

do you think this led would be ok.?
5mm 20,000mcd WHITE LED 3.4V

My current one is a 5mm RED CLR 12,000mcd 2.3v.

Kind regards

Vernon
#2
I did a Re solder  didn't make any difference. Led's do not light up even with all knobs on full.  :( Would of be nice to here the difference in the clipping.

Led 1 (+) to square of D3 and LED 2 (-) to the round of D4

cheers
#3
Tech Help - Projects Page / EgoDrive LED Clip mod
March 05, 2012, 12:06:17 AM
My LED Clipping mod doesn't seem to work for me, Have tryed a few different types of  led's . Had the gain and tone on full can not here any change in the sound and still no luck.

Any thoughts on a led type and spec. mine current one is a 5mm RED CLR 12,000mcd 2.3v  which doesn't work either.

Any suggestions very welcome.

Great sounding pedal other than the clip mod.
#4
Tech Help - Projects Page / Re: EgoDriver problems
March 02, 2012, 11:50:13 PM
Hi there, I seem to have the same problem. LED Clipping mod doesn't seem to work for me, Have tryed a few different led's as well. Had the gain and tone on full can not here any change in the sound.

Any thoughts on a led type and spec. mind is a 5mm RED CLR 12,000mcd 2.3v at the moment which doesn't work either.

Any suggestions very welcome.

thanks. Great sounding pedal other than the clip mod.