1
Build Reports / Re: MadBean Collaboration Builds
« on: December 13, 2019, 06:19:08 PM »
Man, those are whoop ass! Nicely executed.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Love the artwork on all of these.+1
I had to re-upload the Runtime Error docs because the DC Jack was slightly off-center. If you downloaded it, delete that and get it again.How can I buy it if it’s free?
The Flunkee is up now.
I had the wonderful experience of accidentally overwriting the new 1590A template I had spent several hours on and then found out my automatic backups had not been working since Thanksgiving. So I lost half a day recreating the template. But, it's all good now!
Runtime Error doc is up. I should have a few more up tomorrow.
... was anyone else hoping for a 404 on the pdf?
BwahahahahaI can't believe some people need to be told to not try and get a sun-tan on their perineum
'taint smart, that's for sure.
I agree. These parts are are dirt cheap and are coming from Taiwan.^^^ +1 He said it best, it’s just a hobby (for us). If I was building for bank( like several of you on this thread), regularly, I would user mouser most likely. I think small bear’s shipping is just too high.
Sent from my iPhone using Tapatalk
The only thing about these conversations that I really shake my head at is the argument (which is common) that Tayda parts are equivalent to other, vetted parts based solely on the fact that a builder hasn't had issues with a relatively small sample size building and without observation over extended periods of time. Much of the hardware is clearly built poorly if one really takes the time to compare it to other parts.