News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - wainer said

#1
Quote from: selfdestroyer on January 31, 2018, 08:01:31 PM
Quote from: wainer said on January 25, 2018, 11:51:59 PM
Good night, I made this pedal but it presents a horrible pop when triggered: even without the led! Does anyone have any suggestions?

thank you



Are you testing this pedal by itself or with other pedals? I would isolate it with just your guitar and amp.

what are you powering it with? If its a OneSpot, is it the only thing plugged in or is there other pedals using the same chain? Try it with its own power source.

Making sure that R1 is 1M and not 1K or any other value.

All I can think of off the top of my head.

Cody

The only way I found was to put a buffer in the pedal output.

Thanks
#2
Good night, I made this pedal but it presents a horrible pop when triggered: even without the led! Does anyone have any suggestions?

thank you
#3
What would that VC entry ? this layout? tanks
#4
In the layout of the Sea Urchin and used the 7805 ? or 78L05 ? because I know I need to reverse the pinout
#5
Hello you have the layout of the Naga Viper ?
#6
Hello Guys!!
What's the correct voltage regulator stop this project? 78L05 or 7805 , because the layout seem to have a correct 78L05 ?
#7
Ok Thank you all!! ;)
#8
jimilee you have which are the board dimensions? Please!

Tanks
#9
Does anyone have the PDF SEA Urchin Deep Blue Delay ?
Or is the size of the board ?
I found a sign on the internet so that the measures do not have the PCB !

Tanks!!
#10
Ok Thank for your attention!!
#11
OK cooder k my email and wainer7@hotmail.com, tanks
#12
Ok Tanks for help but i not find Layout!!
#13
transfer PCB  because of the page layout does not have
#14
Hello anyone have the layout of the Runt (Proco Rat) that can provide for Download ;)