Ok so I'm an idiot, I have worked with vero and built my first two pedals and then went to mod my tube screamer 💡 Great idea in concept except I held my iron to the pad for to long and lifted part of the trace. It's the 4.7k resistor and 20nf input cap. Looks to my newbie eyes that it's the VR section of each component that got lifted. There connected on the underside so that's how I managed to kill two birds with one stone. If anyone knows what else I can point to point wire them to I'd be really grateful. Or the easiest way to fix my mistake. I'm trying to go through the schematic and fine components I could but it's hard for me I think the 4.7 k can be connected to the 510k resistor(if it's close enough) because it also goes to VR. or I'm I sadly mistaken about how to fix it. I'll attach a picture and I appreciate anyone who takes the time out of there day to post suggestions