Super helpful. I'll take a look. Thanks!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: davent on October 27, 2021, 08:41:18 AM
Ohmite makes some knobs in the size range you're looking for but they are crazy expensive and i haven't found anyone with stock, just 10 piece minimum orders to get them stocked. Maybe someones doing knock-offs of those.
Quote from: madbean on October 26, 2021, 04:11:39 PM
I have both of these knobs which are pretty large. To illustrate, I have include a banana for scale. Note, the banana is not included. His name is Butch. Butch the Banana. We have many fun adventures hiking through the mountains on weekends. However, he does not like mountain gorillas.
Quote from: benny_profane on April 13, 2021, 03:53:35 PM
Also, since you're including LED clipping, you can replace the op amp clipping (no clipping) with another diode option if you'd prefer.
Use the same DPDT switch, but put the anti-parallel LEDs across the two center lugs so that the wires and the LED leads are connected to the same lugs. Solder your new clipping options in the spot where the LEDs were. The LEDs will always be in the circuit, but as long as the Vf of the other diode option you choose is lower than that of the LEDs (e.g., 2x1 asymmetric silicon is my favorite here), they will conduct before the LEDs do. I think that the op amp clipping is rather harsh with the Rat, so that would be my personal solution here.