Messages

Yes, bypass works fine.

I thought I did a pretty good job until I hooked it up. There is a very pronounced hum that does not vary with the pots on the pedal only the volume on the amplifier. LED lights up and it's fine on bypass.

My first suspect is that I cooked the build. I've noticed a tendency to dwell on a pad . I'm going to literally could 2-3 1000 for each solder connection. My second suspect is my soldering itself. It is where I need to improve the most. Failing that, am I populating the board incorrectly, are my diodes backwards, etc?

You may not be able to see it, but the backside of the pots are covered in double-sided tape. Those dust caps from small bear/mammoth are nice but they take up a lot of room.

Allright, guess I'll just build the 9V version.

Hey everybody, kinda new here. Been lurking for a few months doing a lot of reading and searches. I'm stumped though. I want to run the TH Customs Valvetizer 1.5 at 12 volts. I thought I had come across some info about beefier components like 100V caps, etc, but for the life of me I can't find that again. I also am wondering what other mods would need to be made?

I would appreciate any help and if this has already been asked and answered, I would appreciate being pointed in the right direction.

Thanks much.

-Mike