Thnks you guys, as i tell you i'm really noob...
I understand that i'm going yo make a mistake, i read again the zirconia instruction... my english is not so good and technicals made translation hader. They suggest to use the LT1054 as IC1 in the 3PRR (the once i called pss3
) because of the power consumption of the VTL5C3,
at the first reading I understood to exchange them but thanks to your considerations I understood that they are not the same components
Ok, so... AWG24 and LT1054 8 pin through-hole the cheaper
I understand that i'm going yo make a mistake, i read again the zirconia instruction... my english is not so good and technicals made translation hader. They suggest to use the LT1054 as IC1 in the 3PRR (the once i called pss3
) because of the power consumption of the VTL5C3, at the first reading I understood to exchange them but thanks to your considerations I understood that they are not the same components
Ok, so... AWG24 and LT1054 8 pin through-hole the cheaper
