Hi everyone, my first post to greet you and have a couple of clarifications.
Part one, presentation:
I am a singer and bass player, I am quite an expert on electricity (I am an auto electromechanical) but I am absolutely noob to electronics: pcb, cap, res, trick track etc ...
I decided that my first quest in this DIY world will be an optical compressor: Zirconia (for bass)
so...
Part two, clarifications:
what kind of wire do you recommend using in connections? AWG22? 24?
In zirconia for bass it's recommended to use the pss3 so my vactrol will be the LT1054 but there are 4 versions !!!
the LT1054IP
LT1054CP
LT1054CPE4
LT1054IPE4
Which one should I take
Thank you
Part one, presentation:
I am a singer and bass player, I am quite an expert on electricity (I am an auto electromechanical) but I am absolutely noob to electronics: pcb, cap, res, trick track etc ...
I decided that my first quest in this DIY world will be an optical compressor: Zirconia (for bass)
so...
Part two, clarifications:
what kind of wire do you recommend using in connections? AWG22? 24?
In zirconia for bass it's recommended to use the pss3 so my vactrol will be the LT1054 but there are 4 versions !!!
the LT1054IP
LT1054CP
LT1054CPE4
LT1054IPE4
Which one should I take
Thank you