I know nobody manufactures them, but with 3D printing so prevalent, I'm sure somebody could make them.
Transparent resin printing
The most practical use for these would be to add LED lighting to vintage pedals without having to drill or modify in any way. The washers could either be for a 1/4" jack or the stomp switch. With how ridiculously bright LEDs are these days, I'm sure the light would bleed out just fine.
Transparent resin printing
The most practical use for these would be to add LED lighting to vintage pedals without having to drill or modify in any way. The washers could either be for a 1/4" jack or the stomp switch. With how ridiculously bright LEDs are these days, I'm sure the light would bleed out just fine.