Author Topic: Fat Pants JR. Debugging. T1 isn't biasing?  (Read 329 times)

blearyeyes

  • Electron Doctor
  • *****
  • Posts: 1390
  • Like so many others, my name is Dan.
    • View Profile
Re: Fat Pants JR. Debugging. T1 isn't biasing?
« Reply #15 on: February 12, 2018, 07:10:00 PM »
No you just put whatever you want into the little blue socket and close the lever Push the button and it will read out information including what pin on a Tran is in what number socket. Just use the first three holes in the socket for Trans 1 and 3 for anything with two wires. 
I sometimes build pedals as "Dan"
I built peddles for Bat Thumbís car.

blearyeyes

  • Electron Doctor
  • *****
  • Posts: 1390
  • Like so many others, my name is Dan.
    • View Profile
Re: Fat Pants JR. Debugging. T1 isn't biasing?
« Reply #16 on: February 12, 2018, 07:10:47 PM »
Canít hurt anything.
I sometimes build pedals as "Dan"
I built peddles for Bat Thumbís car.

elenore19

  • Diode Destroyer
  • *
  • Posts: 42
    • View Profile
Re: Fat Pants JR. Debugging. T1 isn't biasing?
« Reply #17 on: February 13, 2018, 03:18:20 PM »
I assume I just check the values against a data sheet or something?
Or does it literally just say "good" or "bad"?