A quick question based on just a few minutes troubleshooting the switching board for the Blueprint pedal since I think the relay for the switching board might be defective. The audio and switching boards are fully assembled and wired together, but have not been installed in the box. The wiring connections and positive and negative voltages on both boards look OK, including the 5v power going to the pic. The LED turns off and on when the momentary switch is pressed. Plugging in a guitar and speaker, the bypassed signal is OK, but the relay does not switch to the in/out connections that go to/from the Blueprint board when the switch is pressed and the LED comes on. Continuity exists between the in and out jacks even when the LED comes on when the switch is pressed. When pressing the momentary switch, I can only hear the relay click with every other switch press, while it remains silent on the other (unlike the soft clicks I can hear for each press on other switching boards). Is there is another plausible thing to check that would have this same symptom before I unsolder the jack and relay to put in a replacement?