Author Topic: Sparkle drive/green Rhino...  (Read 242 times)

Raz78

  • Diode Destroyer
  • *
  • Posts: 11
    • View Profile
Sparkle drive/green Rhino...
« on: March 03, 2019, 10:21:53 AM »
...sparkling Rhino? Hi guys, instead of just routing a Green Rhino thru a regular clean blend unit etc. - would it make sense in anyway to combine in with the "clean" section of Sparkle drive? I understand a little circuit wise, but not enough yet so before i start breadboarding i wanted to ask and perhaps/hopefully get some pointers towards how to get it done in a proper way. See attached, thanks in advance.

Rockhorst

  • Electron Doctor
  • *****
  • Posts: 907
    • View Profile
Re: Sparkle drive/green Rhino...
« Reply #1 on: March 03, 2019, 10:43:21 AM »
The Sparkle Drive is a screamer, the Green Rhino is a screamer...so...yes

Breadboarding won't hurt your wallet or anything else, so go for it.

Raz78

  • Diode Destroyer
  • *
  • Posts: 11
    • View Profile
Re: Sparkle drive/green Rhino...
« Reply #2 on: March 03, 2019, 01:03:21 PM »
Rockhorst thanks. Actually my wallet says go buy a GR and a parallel mixer, my creativity/energy is torn between practice/instrument time over learning basic circuit stuff. Ill proceed.

EBK

  • Electron Doctor
  • *****
  • Posts: 1267
  • Eric K.
    • View Profile
Re: Sparkle drive/green Rhino...
« Reply #3 on: March 03, 2019, 02:28:35 PM »
A sparkling rhino? 
A Rhinestone Rhino?
Not affiliated with Oatey, makers of the world's best and most delicious* low tar solder paste. Ask for Oatey -- It's the juiciest!

*Solder paste is not food.  If ingested, seek medical help promptly.