News:

Forum may be experiencing issues.

Main Menu

Madbean Total Recall question

Started by ckim715, February 12, 2019, 03:09:30 PM

Previous topic - Next topic

ckim715

Hey all,

I built a Total Recall and biased it per the revised instructions (pin 7 and 14/15 of the V571 for Gain 2). It works but...it just doesn't feel right. I can get self oscillation, but that's not until like max feedback. I only get one or two repeats until the feedback pot is at the halfway mark. Any thoughts?

On top of that, I feel like the repeats are very...abrupt? Is that normal? The only other analog delay I have to compare to is the Aqua Boy I built, and the repeats seem much more organic.

Thanks all1
-Charlie

teknoman2

Post your voltages of the compander (v571).
You should have -4.7 volts on pin 7 of V571 and -13 volts on pin14 & pin15.

Gain 1 and Gain 2 trimmers affect the repeats.
If everything looks right, check the resistors after the compander till the FBK pot (r12,r14,r17,r19,r21,r25,r26,r27,r32,r33).
Cheers,
Panos

ckim715

Thanks for the assist! Pin 7 is reading -5.6, and pins 14 and 15 are reading -12.95.

Curious as to why pin 7 is running -1 v higher than normal...
-Charlie

teknoman2

Yeah thats a bit odd, despite that check resistor values of R9, R10, R11 and last R12, R13.

ckim715

Resistor values are all correct for R9-R13. 68k for R9, R10, R11, 24k R12, 51k R13. This is weeeeird.
-Charlie

ckim715

-Charlie