News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - luks999

#31
Quote from: alanp on May 10, 2015, 07:04:52 AM
Don't know whether it would have worked, but with that huge knob it could have been cool to have the LED below the skirt and shine from underneath.

thats actually a very cool idea :)
or use transparent knobs and leds in combination
#32
im soon gonna build the 2015 version, and solder the ldrs the same way you did
no light shield?

nice job man :) dig the big knob
#33
love it :)
very nice to see some different arrangement of the pots ;)
very innovative build
#34
Build Reports / Re: 3 new pedals
May 09, 2015, 05:48:14 PM
awesomeness  8) very cool, especially the mutron
did you use waterslide decals?
#35
hmm i would check the pot wiring...
the error has to be in the LFO section
good luck man ;)
#36
good luck man
i ordered tze smallbear specials. curious how they sound, let me know :-)
#37
forget what i just wrote... i thought the "L" on the pcb refers to the "L" in the schematic
you wired it ok, but left the bypass LED out, whats ok

sounds like wrong parts, have you checked them again?
how does the resistor update improve the situation?
#38
hmm i dont think thats the problem though...

im looking at the wiring diagram in the build doc and it doesnt look right to me.
looks like when the effect is switched on, the L pad is pulled to ground, what of course causes the LED to go off.
in my opinion it must be the other way round, when the effect is switched off, then the L pad must to to ground, what causes the LED to go off
#39
thats correct, it doesnt matter how you mount the dpdt
the switches look correct.

what about d5 and r46, did you solder them on the other side of the pcb ?
#40
are you sure you wired all the switches correctly? did you mount them to the pcb?
fotos would be helpful
#41
can you post some pics again from pcb up / down and the wiring (especially RR) ?
when you measure the supply voltage on the pcb, what does it show?
#42
Build Reports / Re: Monolitten 121
May 06, 2015, 09:43:47 AM
fantastic :) looks very professional :)
#43
Build Reports / Re: Smoothie 1590a
May 06, 2015, 09:42:17 AM
very clean outside & inside :) well done sir ;)
#44
hi

do you mean, the pedal works but only on "modern" mode you get no chorus sound?
do you get clean signal or no sound?

pictures of your board and the wiring can be helpful
#45
great stuff :) looks fantastic  8)