Hello! I am a beginner, obviously, and am having a dilemma that despite all my internet research (hours of looking up specifics on pots, caps, resistors, all the parts needed for my pedal) I am unable to solve.
My Problem:
This is my first pedal build, and I started off with the MANGLER. I've spent a lot of time learning how to read schematics, and about the parts, and i am fairly certain I have it hooked up properly on my breadboard. HOWEVER, It passes signal unaffected... I have rebuilt it multiple times, all to no avail.
The only change modification from the schematic I have made is to get a 1kC pot as opposed to a 1kB pot (i read that the reverse taper on the 1kC works better).... Is this where I have made my mistake?
Any advice would be greatly appreciated, as I am not even sure what to look for or ask in trying to solve this issue.
Thank you in advance!
My Problem:
This is my first pedal build, and I started off with the MANGLER. I've spent a lot of time learning how to read schematics, and about the parts, and i am fairly certain I have it hooked up properly on my breadboard. HOWEVER, It passes signal unaffected... I have rebuilt it multiple times, all to no avail.
The only change modification from the schematic I have made is to get a 1kC pot as opposed to a 1kB pot (i read that the reverse taper on the 1kC works better).... Is this where I have made my mistake?
Any advice would be greatly appreciated, as I am not even sure what to look for or ask in trying to solve this issue.
Thank you in advance!