From the "gut" shots I've seen. It looks as though Allen Bradley resistors were used for some of the locations. Anyone know which resistors they would be according to the Aristocrat docs? Also, will they make any notable difference in the sound? Thanks for any help.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#82
Would it be possible to put a link to your home page on the forum main page? It would make navigating to look at the project docs a little easier. 
#83
Open Discussion / finding "mojo" parts
August 03, 2010, 01:38:08 PM
Anyone have good ideas/sources for mojo parts out of old electronics etc... I've got a few yard sale finds, but nothing to cool..
#84
General Questions / Aquaboy sound clips?
July 12, 2010, 04:05:34 PM
Anyone care to post a sound clip of their completed aquaboy? How does it compare to a Carbon Copy?
#85
Open Discussion / What's going on here?
July 12, 2010, 12:41:28 PM
In the profile section it says for everyone except madbean. "What's going on here?". Can we change this? Or do we have to move through ranks to change what it says. What are the stars for?
#86
General Questions / Aristocrat question
July 12, 2010, 12:36:42 PM
Noob alert! How does the switching work on this pedal? I'm looking for a pedal that can to go from a light drive and then switch it to something with more gain without a boost in volume. My Tim pedal can do the light to heavier gain, but I have a big boost in volume because of the circuit design.
#87
Build Reports / Lizzy (aka Serendipity)
July 12, 2010, 03:22:18 AM
Been working off and on with this one for about two months. Its my second build (first one a byoc). I etched the board thanks to madbeans great layout, ordered parts and the rest is history...
All jacks top mounted, had to dremel the lid inside lip to get it to fit flat. Can't even tell when the lid is on. It was time consuming with the layout/drilling as I had to make sure that nothing would interfere with each other. Things are tight at the top, I almost didn't think it was possible with the pots and jacks all in the same area. Using a 125 case would have been easier, but I wanted it in a 1590B. It took some tight spacing to get a battery in there but it worked. Sounds nice, a but little less gain than expected. I have no personal exp with a real zen drive. Painting was a pain, kept getting little things going wrong. I tried to be neat since I knew I would post the guts
Constructive comments welcome..still learning.
All jacks top mounted, had to dremel the lid inside lip to get it to fit flat. Can't even tell when the lid is on. It was time consuming with the layout/drilling as I had to make sure that nothing would interfere with each other. Things are tight at the top, I almost didn't think it was possible with the pots and jacks all in the same area. Using a 125 case would have been easier, but I wanted it in a 1590B. It took some tight spacing to get a battery in there but it worked. Sounds nice, a but little less gain than expected. I have no personal exp with a real zen drive. Painting was a pain, kept getting little things going wrong. I tried to be neat since I knew I would post the guts
Constructive comments welcome..still learning.