Messages

This morning (May 15th) I finally received an email from Mammoth. They took accountability for the fault in the drilling process. There is a new enclosure on the way, no extra charge, plus I get to keep the one with the wrong drill holes. The new box should also be here by Friday (1st class ship). So, after an email and 2 Facebook posts, the issue seems to be getting a lot better. Hope all goes well for the rest of yous. And if they fumble, hopefully they can recover like they did for me.

On another note, I just bought a bunch of drill gear to do it myself. 

Mammoth electronics have let me down once again. I asked for H-Top jack locations and this is what I receive. Also, ordered on 5/2 and just received it today 5/14. They never informed me they had a delivery delay, only found out since I ask what was taking long. Called them when I received it: they picked up and put me on hold for about 10 seconds then got hung up on. Called back twice to no respond. Email hasn't been answered either. Highly disappointed.

I will adapt my jacks to fit, but I can't ever get a 100% correct order from them. Probably won't return it since shipping back would already cost me twice the price of the enclosure. Just sharing my experience, hope it goes better for the rest of yous.

Great, that's good to know. Thanks for the help/advice guys.

On another note, I am unable to find some of the ceramic caps. Can I use MLCC (leaded) instead? And, it is possible to mix MLCC and ceramic caps on the same build?
Similar, Can I use Poly Film box with Mylar on this build?

Here the link to the 5pF ceramic cap I am looking into:
https://www.mouser.com/ProductDetail/810-FG18C0G1H050CNT6

I've attached 3 pic for easy reference to the build

Hi crew. I am currently trying to build a Leviathan delay [wamp faux echo]. At this state, I'm about to order parts, and ran into a bump.

The Leviathan delay needs a few electrolytic capacitors. I need a 10uF, 47uF, 100uF, the PDF says 16v min. On the website (Tayda) I find mixed sizes and voltage.

10uF  5x11mm 25v
47uF  5x11mm 50v
100uF  6x11mm 50v

Would it be okay to use these components on this pcb?