News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - hobogoblin

#1
Quote from: GermanCdn on November 20, 2012, 10:59:37 PMJust as an aside, you have ordered and built a Road Rage to go with the Pasty Face, correct?  The "normal" 9V wiring won't work with Pasty Face as you need a positive ground effect.  Unless you're only going with battery power, in which case you just have to reverse the leads.

... I have ordered one now. Pretty new to this, anything else you think I'll need?
#2
How Do I? Beginner's Paradise. / Re: First build help
November 20, 2012, 10:52:11 PM
Hmm OK, well I guess I'll put this on hold until I order more parts.

Thanks, I was really curious how this would all fit together -- it wasn't making sense.
#3
How Do I? Beginner's Paradise. / Re: First build help
November 20, 2012, 10:09:46 PM
Awesome thanks.

Next question if you don't mind.  I have all the resistors and capacitors soldered in now. I'm starting on the pots, but I just noticed that the instructions http://www.madbeanpedals.com/projects/Pastyface/docs/PastyFace.pdf don't really go into how to hook up the IN/G/OUT. On the Pasty Face there is one spot for IN one for Ground and one for OUT.

The Jack I have have 6 spots used to connect it to something:


I imagine I would need two of these jacks, one for IN and one for OUT. So that's twelve spots but one 2 soldering points on the PCB.  Also what do I do with the ground spot?
#4
How Do I? Beginner's Paradise. / First build help
November 20, 2012, 08:39:23 PM
Hey,

I've never built a pedal before but have some experience in building arduino projects and the like. So I thought I'd give this a shot. I ordered three PCBs which arrived today and had a getting started question.



Basically, what do i do with those red lines? The impression I get is that I am supposed to solder a jump wire from one to the next, for instance from R3 to C8. If so how should I go about this? Solder both the jump wire and the resistor together where it's indicated and then the capacitor and the other end of the wire as indicated?

Thanks