Messages

Ah, good to know! There is an Ace Hardware nearby. Let me know what you find. I can swing by there for sure.

Thanks for this! I'll order some from smallbear.

Can someone send a link to the plastic screws and spacers needed for Rolo's Liquid Mercury? I check my local hardware stores and don't see anything even close. Thanks!

Incredible!

Hey, what is that enclosure? I'd love to get a few of those for some synth stuff I've been building.

If programming the chip isn't too hard, I'd order one too!

Are you selling the PCB and programmed chip?

Thanks!

Where can I get one of these?

For the Sharkfin, can I use a TL071 in place of the LM741 ICs?

Dah! I just placed an order two days ago!

Lovely!

Got a question. Which cap do you change to get darker repeats on the PP? I love that pedal but I find the repeats a bit to unfiltered.

Very nice! Very curious about this circuit. Also, what's that 3PDT board?

Try a lower value for the output pull down. Like 100k-500k. That's worked for me on a few occasions.

On VERO
For clean: Simplified OC-2 (only one octave down)
For synthy: Robot Devil

Love both of these.

I was wondering if there is a way to kill the dry signal, like the Stage Fright, vibrato mod?

Disconnect a 150K resistor going from the first opamp stage to output transistor.
I did this and did not find the vibrato to be very musical so I ditched the mod all together.