Messages

Hello everyone i just finished an aquaboy with the mod board and when the pedal is bypassed y can hearva clock whine and also if i max the feedback i can hear oscilattion bleeding through. Any ideas to how i can stop the effect bleeding through when its bypassed? Has anyone manage to getvthe aquaboy to work without this problems? I saw that many people where complaining about the same things. Im using shielded cables from both jacks directly to the 3pdt instead of the pads in the board but that trick didnt solve the problem

Hello. Sorry to bump this old threat but im having the same problem and the shielded cable from the jack to the switch didnt helped... Do you guys have any other clue to this problem? Pedal sounds great when ON and the whine stops when the pedal is on. But in bypass i cannot turn it off. Only with the trimpot in 1 the whine stops but at maximum delay i only get slapback time

Hello everyone. I just finished my aquaboy and sounds fantastic but im getting a high pitch squeal when the pedal is bypassed. I made it with the MOD board and when i engage the MoD with the pedal bypassed the high pitch squeal oscilates at the rate of the MOD. Any suggestions? I set all the trimpots to the center and didnt calibrate them yet

Thanks everyone, im going to check everything later and report again

Hello everyone. I built a total recall and it sounds pretty good but it has too much distortion. Im having distortion signal on ic6s input. Is that normal or should i have clean sigal there? Thank you very much!!

Where you able to slve this? im having the same problem. No MOD