News:

Forum may be experiencing issues.

Main Menu

sunking troubles

Started by t-rack, December 31, 2010, 12:15:24 AM

Previous topic - Next topic

t-rack

so i finally got some sound out of this thing after some minor trouble-shooting,and i found d3 was bad, but now im getting a signal through the pedal but it sounds almost over distorted and if i turn the gain up all the way it sounds like a fuzz pedal! the only thing that i noticed was that pin 7 of ic2 was less than 1 volt even after swapping out the chip.
any thoughts?

stecykmi

check the values of the resistors again, you might have too high of a value in a feedback loop somewhere...

this will probably take you a while, there are a lot of them...