News:

Forum may be experiencing issues.

Main Menu

Re: 3PRR Set-up

Started by K3yPr0gg3r, October 04, 2016, 11:59:49 PM

Previous topic - Next topic

K3yPr0gg3r

Hi,

I purchased 2 3PRR boards, (3PDT + Road Rage in one), yesterday. I'm building "Faultline", and I want to run it at 18V using my 9V adapter...(so as a voltage doubler). I've included a pic of how I think it might be connect, but not sure.

Also, it states in the build docs, "I need +18v output for my overdrive pedal (or whatever)...
Solder everything except C5, C6, C7, and REG to the Road Rage PCB. Connect your DC jack to the
"DC" pads and take the output from +18/G. Jumper the two C6 pads to connect pin5 of IC1 to ground." So I don't use C5, C7, OR the Regulator if I'm trying to set up a voltage doubler?

Thank you for any help...


madbean

J1 and J2 are for soldering input and output jacks. Use S (send) and R (return) for the FX in and out.

K3yPr0gg3r

Thanks Brian. I don't need those other components including the regulator when setting up to voltage double?

Jebus

Nope, just like the docs say: C5,  C6,  C7 and regulator are not needed.

K3yPr0gg3r

Cool... And here I thought it was going to be difficult! Thank you...

K3yPr0gg3r

Sorry, just to confirm. J1 is IN and J2 is OUT or visa versa? On every other breakout I have IN is always on the left.

Thank you

madbean