I have an old Current Lover board (not exactly current anymore) that is still only partially completed. I figured this would be the year I finally get it done but I have a few things in mind. I was hoping to try doing some TZF experimenting with it, using the send & return pads. What is the easiest way, on this version of the board, to kill the dry signal? I know on the 2015 board it's just a matter of lifting R28. On the 2011 Current Lover board, am I lifting R25 to kill the dry signal?
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Questions / Current Lover 11.2011 version, How to Kill Dry Signal?
July 12, 2021, 01:14:11 AM #2
General Questions / Current Lover Manual Sweep?
April 02, 2015, 11:35:46 PM
I'm considering building the Current Lover but I want to put it in a wah shell and set it up so I can manually sweep through the filter, when in filter-matrix mode. This may sound daft, but I don't see a "Manual" pot in the schematic. I remember always having one on any EH Mistress I played through.
Pages1