I built the CurrentLover 2023 in the MN3007/18V configuration. It worked right away and sounds like a flanger should.
I followed the setup instructions exactly. However, through the entire range of the Clock trimmer, there are always clock chirps as it peaks. There is no setting that eliminates them, even all the way up.
Possibly related: the build doc lists a 10k trimmer for Clock in the tables, but the board graphic on page 3 shows 20k. I'm currently using 10k
Any initial advice? Do I need to adjust some values somewhere (ie a 20k trimmer)?
I followed the setup instructions exactly. However, through the entire range of the Clock trimmer, there are always clock chirps as it peaks. There is no setting that eliminates them, even all the way up.
Possibly related: the build doc lists a 10k trimmer for Clock in the tables, but the board graphic on page 3 shows 20k. I'm currently using 10k
Any initial advice? Do I need to adjust some values somewhere (ie a 20k trimmer)?