Print Page - Anyone have one of these knobs?

Title: Anyone have one of these knobs?
Post by: BuGG on July 20, 2018, 08:09:44 PM

Anyone have one of these knobs, or a pedal that uses them? I'm just curious about the size (maybe up against a 1510 or MXR?)...

I've contacted Daier for a datasheet/drawing but they apparently can't provide one for this one. ::)

It looks like some sort of Davies clone but I can't figure out which one.

(http://www.pedalpcb.com/images/knob.jpg)

Title: Re: Anyone have one of these knobs?
Post by: somnif on July 20, 2018, 08:16:23 PM

Well I found the technical drawing, if you can read mandarin anyway....

http://p.globalsources.com/IMAGES/PDT/SPEC/824/K1147914824.pdf

Title: Re: Anyone have one of these knobs?
Post by: BuGG on July 20, 2018, 08:32:41 PM

Heeey, that's much more info than I had so thanks!

I reckon the diameter is around ~22mm not counting the pointer.

Title: Re: Anyone have one of these knobs?
Post by: alanp on July 20, 2018, 11:38:39 PM

Whatever it is, it looks pretty cool!

Title: Re: Anyone have one of these knobs?
Post by: HamSandwich on July 20, 2018, 11:47:03 PM

Me likely. Where are you buying them from?

Title: Re: Anyone have one of these knobs?
Post by: chromesphere on July 23, 2018, 04:15:17 AM

Interesting shape. Daier knobs are not the best quality though, ill just throw that warning out there.

madbeanpedals::forum

General => Open Discussion => Topic started by: BuGG on July 20, 2018, 08:09:44 PM