How about a Boss OC-2 Octave Pedal? That would be a sweet addition!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: bcalla on January 01, 2014, 02:15:54 PMQuote from: rullywowr on January 01, 2014, 12:58:26 AM
It's great in Inkscape because you can put the knobs and hardware on separate layers and just hide them before printing. The alignment functions in Inkscape are really powerful too
+1 Inkscape layers make layouts & alignment pretty straightforward. Another helpful trick is to import the board image from the build doc pdf as the bottom layer. Then you can make sure your drill guides line up with the board components, and that your jacks don't interfere with board placement. Search this forum for 'Pedal Vectorpack', it contains actual sized components - jacks, pots, etc. - which I place on another layer.
Quote from: rullywowr on January 04, 2014, 03:57:21 AMQuote from: blackedition on January 03, 2014, 07:42:51 PM
the build looks and sounds awesome. i really like those 3pdt breakouts! the trim pot control for the led is sweet. where did you get those breakouts?
Thanks! Those breakouts are something I whipped up this summer. It's an added cost using a trimmer instead of a regular resistor or measuring brightness beforehand, but I do like them. Makes it easy to dial in LED balance between two different LEDs. Plus it's more knobs to tweak...