I'm ordering parts for a Wolfshirt build. Will that PCB fit in a 1590B? It looks a little wide.
Also, can I sub a 56n for the 50n in C11?
I'm not sure, but I'd probably go with 125b on that. I'm pretty sure I've seen a build report here in one of those, but not in a 1590b. 125b is so much easier to work with anyway IMHO.
I normally sub 47n for 50, it seems closer, but 56n should be ok too. Socket it if you want to experiment later.
The last page of the Wolfshirt's build doc has a drill template to fit it in a 1590B/1290NS. It looks like it's made to fit that size almost exactly. I agree the 125B would be easier, its a little wider, a little bigger on the length size and good amount deeper. But if you want a challenge, yes it will fit. :)