News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - CMinusInGym

#1
General Questions / Is this a possible pedal?
March 02, 2011, 09:13:40 PM
http://www.duncanamps.com/tsc/index.html
Found this interactive tone stack calculator today and was wondering if some of the layouts could be used as a pedal.  I think these are tonestacks for an amp, but I think it would be great as an EQ pedal.  Is this possible?
#2
Tech Help - Projects Page / Re: Egodriver LED Problem
February 13, 2011, 08:25:16 PM
Alright, I figured it out.  In case anyone else ever gets this problem, it was the SW and input tip connections touching.  It finally works and sounds amazing!  Great pedal Madbean!!!  ;D
#3
Tech Help - Projects Page / Re: Egodriver LED Problem
February 13, 2011, 08:06:40 PM
I partially fixed the problem, but now I have a bigger problem.  The light turns on and of when on/bypassed, but when I plug my guitar in, the LED goes faintly on and the guitar level drops.  When I roll back the guitar volume, the LED grows brighter.  When I turn the effect on, the LED lights up fully and the volume mutes.

(I'll take a picture as soon as I can)
#4
Tech Help - Projects Page / Re: Egodriver LED Problem
February 13, 2011, 07:47:14 PM
Okay, I solved the problem and the LED lights up, but when I bypass the pedal, it stays on.
I think there is an accidental connection, but I'm not sure between which parts.

I'll post a pic as soon as I get a chance.
#5
Tech Help - Projects Page / Re: Egodriver LED Problem
February 13, 2011, 07:00:32 PM
Ok, I tried everything with no avail.  Could it be something else?
#6
Tech Help - Projects Page / Re: Egodriver LED Problem
February 13, 2011, 02:14:47 PM
so if the SW wire isn't connected correctly, the LED won't work?

Thanks I'll check it out!
#7
Build Reports / Re: Egodriver!!!!
February 13, 2011, 03:05:28 AM
Why is there only one wire going to the LED.  I can't get the LED to work on mine, is this because I used both wires into the two holes?
#8
Tech Help - Projects Page / Egodriver LED Problem
February 13, 2011, 02:28:12 AM
Hi, I'm building my first Madbean pedal, an Egodriver OCD Clone, and have a problem with the LED.  The pedal works fine and sounds great, but the LED does not work.  I've tried switching the contacts and even trying a new LED, but neither have worked.  Any idea on what might be causing this?

Thanks for any help!