Topics

Hi All, i've just finished building my first Mudbunny Ramshead. And Im having problems with low volume.
I took some reading of my transistors they are as follows:
Q1 E: 4.03V, B: 0V, C: 0.03V
Q2 E: 4.21V, B: 0V, C: 0.05V
Q3 E: 3,89V, B: 0V, C: 0.03V
Q4 E: 4.69V, B: 0V, C: 1.17V

Any help will be greatly appreciated.

Thank You

1. Sea urchin
2. Effect does not engage
3.-
4.-

Hi, I have just finished building the sea urchin. I have tested it with I/O breakout ox and it worked it was a little bit noisy, but still worked. Then I proceeded to box it using my new 1776 3PDT board. But when I engage the footswitch my guitar signal still goes through but with no effect. Please help.

Thank you

1.Grapevine

2.Pulsating electrical noise, the pulse is beating at 190bpm, I am using a fresh battery. I tested the circuit on my beavis board without realising I missed an electro cap, but I quickly soldered it on and i still get the noise.

3. I suspected it is a solder bridge somewhere, I had problems with the gain pot on the circuit and fixed it by cutting a solder bridges. Also this is only happening on high gain.

4. No substitutions