News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - ralius18

#1
It's been a while since I've done any work on it, but I had a half-finished Wavelord sitting around.
After having to re-solder nearly every cable, when testing it was making a loud hum.
The only time it wouldn't was when there's no power and the switch is in bypass. When power is supplied, even the bypass has the hum.

Here's pictures of the (shoddy) job I've done so far, all the solders look ok I think, and there's no shorts or touching wires from what I can tell - I've run a knife between ones that are close to make sure.
https://imgur.com/a/P0ey7vf

And the sound of the hum
https://vocaroo.com/1ginrlz9NR4T

Has anyone else had a similar problem, or could help with diagnosing the issue?? I'm desperate to get this one finished after so long!
Thanks so much!!