I've seen this with some really high gain circuits. I think jiggling things and touching things might send some signal through it and you see the LEDs light up. I built one once where the LED were glowing super bight until I hooked everything up (ground was the key) and then it worked great. Are you having problems with the circuit or just expressing concern?
ok ill try that out
ok ive wired it all up in the enclosure and its the same thing, it only happens once i place in the opamp but both leds light up on and off as i touch it or move the board/wiring
This happens with no power to the board at all??? Do you have a pace maker? Or maybe a flux capacitor in your back pocket?