News:

Forum may be experiencing issues.

Main Menu

Footswitch PCB

Started by crashguitar, April 23, 2010, 03:16:58 PM

Previous topic - Next topic

crashguitar

I was looking through some of the BYOC instructions and I noticed that they were using a small PCB for wiring/attaching a 3pdt footswitch (I found in in their tremolo instructions). Seems like something like this might make wiring the switch a lot easier. Any thoughts on making something similar?

neiloler

I've used this little jobbie from Small Bear and it works well: http://www.smallbearelec.com/Detail.bok?no=870
OLERAudio - Sole proprietor, engineer, and goofball

CRBMoA


crashguitar

I found them at Smallbear, too. I have used it and really liked it.

Haberdasher

Looking for a discontinued madbean board?  Check out my THREAD

FABBED PCB's FOR SALE:
Now carrying Matched JFETS

crashguitar

Would you be willing to share the artwork?

NoizeD

Quote from: crashguitar on October 10, 2010, 03:43:51 AM
Would you be willing to share the artwork?

if you want to etch your own i suggest you to check this out --->  http://topopiccione.atspace.com/PJ22TPCAssemblySystem.html

Scroll down for pcbs and layouts