Hello all.
I've built a white horse, and it is not working. The bypass board seems to be working properly, and is outputting the correct + and - voltages, but when I turn the effect on the whole signal cuts out. If I crank all of the knobs I do get a very quiet distorted signal coming through, but that's it.
I have a version 4.2 board, and am using the version 5 clipping, with the 1N914 diodes stacked. I was worried I might overheat one of those when soldering them together, could that cause problems with the whole circuit?
Going through and testing the voltages, I seem to have mV readings in a few places where I'm not supposed to have any, and the voltages to the clipping diodes are wildly different from whats shown in the build doc. I also soldered in the big chip in the TLE 2074, would overheating it cause these problems?
All voltage readings were taken with the LED in place, pre-gain cranked, and all other knobs all the way down.
Any help is much appreciated.
Also idk why the photo got all stretched like that but hopefully y'all can see things well enough.
I've built a white horse, and it is not working. The bypass board seems to be working properly, and is outputting the correct + and - voltages, but when I turn the effect on the whole signal cuts out. If I crank all of the knobs I do get a very quiet distorted signal coming through, but that's it.
I have a version 4.2 board, and am using the version 5 clipping, with the 1N914 diodes stacked. I was worried I might overheat one of those when soldering them together, could that cause problems with the whole circuit?
Going through and testing the voltages, I seem to have mV readings in a few places where I'm not supposed to have any, and the voltages to the clipping diodes are wildly different from whats shown in the build doc. I also soldered in the big chip in the TLE 2074, would overheating it cause these problems?
All voltage readings were taken with the LED in place, pre-gain cranked, and all other knobs all the way down.
Any help is much appreciated.
Also idk why the photo got all stretched like that but hopefully y'all can see things well enough.