Hello!
Just got hold of a couple of unmarked 3pdt switches. The others i've got had markings 1 2 3 and a b c etc. So my question is if there is quick and easy way to measure up the orientation? I've tried it myself with my multimeter but i did not get any wiser doing that.
//Mega
In new to building as well, but from what I understand it's this:
- - - throw 1
- - - common
- - - throw 2.
So basically as long as the lugs of the switch are horizontal, you will be fine.
Sent from my thumbs using Tapatalk!
Quote from: stevie1556 on February 02, 2013, 08:41:23 AM
In new to building as well, but from what I understand it's this:
- - - throw 1
- - - common
- - - throw 2.
So basically as long as the lugs of the switch are horizontal, you will be fine.
Sent from my thumbs using Tapatalk!
True story
Thanks alot! It worked! :)
Quote from: Megadeth on February 06, 2013, 08:49:47 PM
Thanks alot! It worked! :)
Glad it worked for you! What circuit did you build?
Sent from my thumbs using Tapatalk!
Uproar and and a serendipity! comming along nice, just waiting for my cases and they are ready.
Ps: Just noticed the reason i could not get good readings....I was pushing the switch to gently so it never actually switched :)