Just finished up a Landgraff Dynamic Overhype aka a TS808 with clipping options. I subbed BC549's for the trannies and use an OPA2134 for the IC. For the clipping options I used 1N914's for the Asymmetric and 2 green 3mm LEDs (didn't have any reds on hand). I have to say I like the green LED's.
This has a very full, creamy yet slightly raw OD sound which is exactly what I was hoping for!
I kinda flubbed on the switch position (should have lowered it just slightly) but I am getting better with laying out my decals :D
(http://i778.photobucket.com/albums/yy62/Airframer_2010/IMGP2439_zps6f993f0b.jpg)
(http://i778.photobucket.com/albums/yy62/Airframer_2010/IMGP2436_zps3bb9ceab.jpg)
(http://i778.photobucket.com/albums/yy62/Airframer_2010/IMGP2432_zpsa2f8aab4.jpg)
(http://i778.photobucket.com/albums/yy62/Airframer_2010/IMGP2431_zps94ed841a.jpg)
Very nice clean build...the carbon res always look good and the blue Led. Yes you make good vero board builds and you have me at it now..lol As if I haven't enough builds on the go.
I will probably build this to :)
The component cabinet behind looks dated with the leather grips, you must be as old as me ::)
Merry Xmas fella, have a good one ;)
__________________
You've got the job 8)
Thanks fendman 8)
I'm not quite as old as that case in the pic ;) . I saved that from the trash at work when we were updating our tool boxes.
I just realised that I have built this in the form of the Rockbox boiling point...I used BC549C instead of what was used which I think were mpsa18 .
The IC was JRC4558 ... and the only other difference was a SPST sw with 470n one side and 220n on the other for bass the other sw was clip.
Might try that IC in it though :)
I love the sustain you get with these OD pedals