Hi everyone. I'm new to all this and am starting with a mangler. Anyone have a drill template for a 1590B box if I'm using on board pots?
You're in luck! The Mangler build document has a drill template on the last page or so. It's set up around the fabbed Mangler PCB with the board-mount pots.
I would still mount the pots on the board and "eyeball" it before you commit to drill. Sometimes those templates are a tiny bit off. You'll have a mm or two flexibility in the pot lugs, but I like to get the drilling as close as possible first.
I see the wiring diagram, bill of materials, schematic, etc. but no drilling template in the project doc. Am I looking in the wrong place?
I just ordered 2 of these to do a couple variations. Funny how easy it is to get really sucked into this stuff.
You're right there is not a drill template.
You could always use this one for the jacks and switch. Then centre the pots yourself.
http://www.madbeanpedals.com/projects/Bumblebee/docs/BumbleBee.pdf
I'll make one right now.
Okay, I have added a drill template to the last page of the Mangler doc.
http://www.madbeanpedals.com/projects/Mangler/docs/Mangler.pdf
Thank a ton MB and everyone else for the suggestions.