I built a Pharaoh on a etched mudbunny but I have the oddest behavior with it on 1 of my 2 amps.
I have no idea where to even start to debug this one.
The pedal acts normal on my Blackstar HT-5. Everything I describe below does not happen on this amp.
But on my Orange OR-15 the volume knob will increase in volume until about 1:00 then start to decrease in volume again as I move towards 5:00. The volume doesn't shut off at 5:00 just get's a little quieter. Also if I put a phaser after the pedal, there is a fairly big volume increase when the phaser is on. But, If I put a clean boost after the pharoah (a guitarpcb stage 3) I don't get the same volume boost, I almost get the reverse effect to where I have to dime the the boost.
One last thing, I did try another mudbunny (violet rams head specs) on the OR-15 and it works and acts normal.
Any ideas?
(http://www.angrykoko.com/pictures/pharoah/IMAG0141.jpg)
Thanks!
Koko