Getting ready to build up my Double Flush board and already have a few LDR's on hand and was wondering if any of them would work in this circuit. I HAVE a VTL5C2 and a NSL-32. The schematic calls for VTL5C1. Any help would be appreciated. Thanks!
I am also in the same boat, want to build one up, and have 9 NSL-32s in my collection of parts, as i had to buy ten for another build.. so i guess this is a bump..
or did you get it going with the nsl32 in the end?
last one I did I did a roll your own with the Tayda cheapo LDR. Seemed to work just fine.
Quote from: juansolo on November 30, 2012, 05:56:58 PM
last one I did I did a roll your own with the Tayda cheapo LDR. Seemed to work just fine.
From Rapid, not Tayda.
The NSL-32SR3 didn't work well, it was too choppy, and couldn't be dial out. Much too responsive.
I've built one with the VTL5C1 and one with a Tayda photocell, both worked, the only problem with the Tayda photocell is you don't get the response out of the Intensity knob that you do with VTL.
Quote from: marauder on November 30, 2012, 06:12:26 PM
Quote from: juansolo on November 30, 2012, 05:56:58 PM
last one I did I did a roll your own with the Tayda cheapo LDR. Seemed to work just fine.
From Rapid, not Tayda.
The NSL-32SR3 didn't work well, it was too choppy, and couldn't be dial out. Much too responsive.
My bad, thought that was a tayda on :-[
I used an NSL32 and it sounds great and works well in all settings.
Thanks dude,
now at least i know i can give it a go and see what happens :)
George