Recently I made the version of modulaterator for veroboard, I tried it with ZZPD but the LED does not blink . The modulation is heard but not flashing LED
This is the veroboard wanted to help me find because the LED does not blink. Thanks in advance ;D
I check the B.O.M. for the ZZSDX and the Rate LED is a 3mm and in my veroboard i use a 5mm led this could be the problem? that it not have enough voltage?
Maybe the LED is connected the wrong way?
Does it work at all ?
ok thomas i will check the wiring connections. and i will post photos tomoorrow.
Thomas sorry for the delay.
The Modulaterator already works but the Led is not workink yet, flashing at the rate.
I found one error in the Vero Board:
- The two resistors (100k) that run from the +9V & GND to the pin 5 should go conected to the pin 6.
Since I Found this error I check my wiring and I found another error, I connect wrong the terminals of the rate pot so i fix it. After that I connect the Board to the DElay 1 Terminal of my ZPDD Board and Work only the Depth Pot cause when i turn it i heard something (i don't know how describe it, sorrry for my bad english i hope you can undestand me ) but when i turn the rate pot anything happend and the Led is still not flashing.
And after that I check the ZPDD Deluxe and i see that the "Opamp LFO" is identical with the Modulaterator Board and i realize that
that the ZPDD Deluxe Opamp LFO use it a 1MC instead a 1MB Rate Pot
I don't Know what is the next step to debug the Board. Thanks For ypur Help
Blessings