Trying to figure out if I can get one in a 1590B.
I found this on the Harmony central forum:
QuoteThe one in my Cry Baby Classic (red) is:
1.5 cm diameter
2.0 cm long with the pins
1.25 cm high
1.25 cm pin spacing
Those should be pretty accurate, as long as you can convert them into your antiquated imperial system.
Just searched for 'Fasel inductor Dimensions' Don't know if it is correct, if you need help converting it to inches, let me know
Paul
Hmm, 1.25mm isn't terribly high. I guess if I needed pots I could use 9mm or side-mount them.
Smallbear sells these, I guess I can ask them, too. :)
Quote from: midwayfair on November 17, 2013, 06:10:32 PM
Hmm, 1.25mm isn't terribly high. I guess if I needed pots I could use 9mm or side-mount them.
Smallbear sells these, I guess I can ask them, too. :)
Watch out, dimensions in
centimeters!!!! 1 cm = 10mm, 1.25 cm is just a hair under half an inch! You're probably right, best bet is to contact SB and be really sure.
Paul
Quote from: DutchMF on November 17, 2013, 06:24:42 PM
Quote from: midwayfair on November 17, 2013, 06:10:32 PM
Hmm, 1.25cm isn't terribly high. I guess if I needed pots I could use 9mm or side-mount them.
Smallbear sells these, I guess I can ask them, too. :)
Watch out, dimensions in centimeters!!!! 1 cm = 10mm, 1.25 cm is just a hair under half an inch! You're probably right, best bet is to contact SB and be really sure.
Paul
Yeah, I know (it was a typo before). Most electrolytics are 11 mm tall, which gives me a pretty good idea of what I'm dealing with.
Wow, they're 19mm tall. Sheesh. My dream of using an Ernie ball VP for my wah pedal is getting increasingly remote,
. :(