Hi mates! This is my own take to the ZeroPoint SDX Delay! It went all goot at first run!
Main features:
- Rate led under Mod Rate Knob (with transparent knobs, man this is epic!)
- 4K7 resistor in series with the slam footswitch (infinite feedback was too loud and too fast!)
(http://paolo.munarini.it/electronics/zeropointsdx/01.jpg)
resistor, diodes and sockets on-board
(http://paolo.munarini.it/electronics/zeropointsdx/02.jpg)
soldering time!
(http://paolo.munarini.it/electronics/zeropointsdx/03.jpg)
caps on-board!
(http://paolo.munarini.it/electronics/zeropointsdx/04.jpg)
internal wiring (not so tidy :P)
(http://paolo.munarini.it/electronics/zeropointsdx/05.jpg)
front panel! I don't mind doing quality prints on my pedals, since I'm the only one that is going to use them ;D so I wrote with my permanent marker all the texts...
Sorry for bad quality pics! they are from my mobile phone...
This is my first madbean build! I really love how creamy this delay sounds on my modular synth!
Woah!
That's a heck of a first post, man! Welcome!
Dude, that's cool! Your pics are more than good enough, and I like that you documented the builds progress, I definitely should do that more! Very nice first post, keep it up!
Paul
Nice one!
For me that was one of the hardest pedals to make, I had some issues drilling out the enclosure just right so I had to over-drill the pot holes and both holes for the jacks and cram everything inside the 1590bb enclosure but in the end, those delays are top notch! Everyone I know that has heard it and knows delay pedals wants me to make them one LOL
GOOD JOB MAN!